Premium Leather Cable Cover
CK® Cables Covers are constructed of durable leather with Velcro.
- Abrasion Resistant
- Heat/Flame/Spark Resistant
- UV Resistant
- Oil Resistant
Cable covers are always recommended for water cooled TIG torches. Designed to protect the lines, and keep them from getting tangled and kinked, which can limit the coolant and gas flow.
For air cooled TIG torches, cable covers are recommended in harsh environments where there is a danger of the power cable becoming cut, punctured, burned,or if you are running a remote amp control and want to protect the control cable.
The 4-1/2" (113mm) wide cable cover is the large cable cover intended for use with the largest, high amperage TIG torches. The fit will be too big/baggy for most hand held TIG torches.
The length of cable covers is generally intended to be a couple feet shorter than the TIG torch leads. This allows room at the machine for the cables to be stretched to the different ports on the machine and water cooler.
Select Length From Drop Down Menu Above.
Examples of suitable torches these cable covers fit: CK-510, CK-MT500, WP-12, W-400, W-500, WP-27, and similar torches.
For very most, common hand held TIG torches, the 3" cable cover is recommended: CK-MR140, CK-200, CK-300, CK-TL300, WP-125, WP-18, WP-20, WP-24, CS310, CS410, W-180, W-200, W-225, W-250, W-280, W-310, and similar torches.
For information on how to install your cable covers, check out this .pdf.