Power Cables Water and Gas Hoses

Weldcraft® WP-20 Series TIG/GTAW Torch Power Cable, Water & Gas Hoses

TIG Torch packages come with either a low-cost PVC vinyl plastic power cable and hose set, or a premium high-flex, non-conductive rubber power cable and hose set.  These materials were chosen because they offer superior insulation properties, and are non-conductive, which is critical in TIG welding hose construction.

The picture on the left shows a braided rubber, and vinyl plastic hose.  Some TIG cables are built with a smooth rubber hose or covered cable with separate gas hose, (not shown) this is common with air-cooled single-piece and two-piece cables.

Note: Torch packages, power cables and hoses can be identified by the part number -- they typically have an "R" at the end of the part number which indicates "rubber" hose material.

Vinyl (plastic) vs. Rubber -- Which is Better?  

It comes down to your budget!  Arc-Zone recommends rubber power cables, water and gas hoses.  Rubber cables are more durable, more flexible, and not as susceptible to melting when exposed to direct heat. 

Note: For certain high-purity TIG/GTAW welding applications a vinyl hose may be preferable, specifically when welding titanium.  If you are interested and want to learn more-- Check out my story over on the JoeWelder.com blog "Rubber versus Vinyl Plastic Hoses, Which is better?"

WP-20 Series Cable Specifications

• Gas Hose machine end fitting is a "B" size, 5/8"  x 18 Right-Hand thread
• Water-In Hose machine end fitting is a "B" size, 5/8"  x 18 Left-Hand thread
• Power Cable/Water-return machine end fitting is a "C" size, 7/8"  x 14 Left-Hand thread.