Weldcraft® WP-17 Series TIG/GTAW Torch Power Cables
TIG Torch packages come with either a low-cost PVC vinyl plastic power cable and hose set, or a premium high-flex, non-conductive rubber power cable and hose set. These materials were chosen because they offer superior insulation properties, and are non-conductive, which is critical in TIG welding hose construction.
The picture on the left shows a braided rubber, and vinyl plastic hose. Some TIG cables are built with a smooth rubber hose or covered cable with separate gas hose, (not shown) this is common with air-cooled single-piece and two-piece cables.
Note: Torch packages, power cables and hoses can be identified by the part number -- they typically have an "R" at the end of the part number which indicates "rubber" hose material.
Vinyl (plastic) vs. Rubber -- Which is Better?
It comes down to your budget! Arc-Zone recommends rubber power cables, water and gas hoses. Rubber cables are more durable, more flexible, and not as susceptible to melting when exposed to direct heat.
Note: For certain high-purity TIG/GTAW welding applications a vinyl hose may be preferable, specifically when welding titanium. If you are interested and want to learn more-- Check out my story over on the JoeWelder.com blog "Rubber versus Vinyl Plastic Hoses, Which is better?"
WP-17 Series Cable Specifications:
- Choose from low-cost vinyl plastic or flexible heavy-duty rubber one-piece, or two-piece cables
- One-piece cables: Both the torch and machine end fittings are 3/8" x 24 male thread
- Two-piece cables: The torch end fitting is 3/8" x 24 male thread, the machine end is a copper eyelet with 1/2" hole, and a 5/8" x 18 right-hand male gas nut.